To make Minion finger
puppets you will need:
Felt
in yellow, blue and black. (Felt packs available in the Range)
Googley
eyes
Cotton
– I used black, blue and a see through thread.
Needle
Pins
Super
glue
Card
or paper for your template
Instructions:
The
first and most important thing is to make a template that will fit
around your finger after you’ve finished sewing. Draw a fat finger
shape and then cut it out to check the fit.
Pin
your finger template onto your yellow felt and cut around it. Do this
twice so you have a front and a back piece.
Pin
the template onto your blue felt and cut around it, this is for their
dungarees. Chop a bit off the top and cut out the dungaree shape. I
did this freehand but if you’re worried you could always cut your
template into the shape you want first and then cut around that.
From
your black felt cut out a long thin strip to use for the glasses, a
small circle for the logo on their dungarees and two arms and hands.
I did originally think of doing the arms as part of the main body but
frankly it was a faff and I’m all about trying to keep things as
simple as possible! This is what your assembled bits of felt should
look like.
Next
start sewing on the pieces that will be on the outside of your minion
finger puppet, you need to do this before you sew the front and the
back together. The order I did mine in was overalls, then black band
for glasses, then the black circle. I left cutting the band for the
eyes until the whole puppet was complete as I wanted to make sure it
was the right length.
The
next thing is the mouth.
Now
you’re ready to sew the two pieces together. Pin them together with
the black arms
in place where you want them, make sure they poke far
enough in that your sewing will hold them in place.
Finally
use some super glue to stick your googley eyes in place and your
minion finger puppet is ready to go. Use one or two eyes depending on
what minion you want to make.
(You
can use super glue instead of sewing but if sewing please be careful)
No comments:
Post a Comment
Note: only a member of this blog may post a comment.